Track connected vehicles news alongside market analysis, provider activity, and connected mobility intelligence from PAVE Insight.
Valladolid hosts connected and cybersecure urban circuit
Valladolid has become an open-air cybersecurity laboratory under a 3.5 million euro RETECH scheme integrating V2X, 5G and edge computing; GMV has delivered V2X and cybersecurity systems, and the project has been funded by Next Generation and regional sources.
Data connectivity trends for automotive systems
The automotive sector has required greater personalisation, autonomy and connectivity, driving demand for smaller, higher-resolution cameras and higher-bandwidth, more integrated connectors to support ADAS and autonomous driving.
SmartTS-PV compliance tester for inverters and V2G
Pacific Power Source has launched SmartTS-PV, a pre-integrated platform that has automated IEEE 1547.1, UL 1741 SB and EN50549 compliance testing for solar inverters, EVSE with V2G and distributed energy resources, and has reduced test durations.
Ethernovia launches HSB networking board for NVIDIA Holoscan
Ethernovia has launched an HSB networking board for NVIDIA Holoscan, enabling direct Ethernet sensor-to-GPU transfer with ultra-low latency, Omniverse integration for real-time simulation, and a software-defined, scalable architecture aimed at accelerating edge AI deployment.
Xos to add V2G across commercial EV line-up
Xos has announced production for April 2026 of V2G-capable school buses and has committed to adding bidirectional charging across its commercial EV range, enabling depot-level energy management, reduced peak demand charges and participation in utility demand-response programmes.
Proposal for V2G-ready label in EU vehicle approvals
Transport & Environment has recommended a voluntary 'V2G-ready' label on EU Certificates of Conformity, specifying interoperability, inverter, charger and data-sharing requirements, and has called for these criteria to be incorporated into mandatory EU type-approval for new EVs by 2032.
Vector and Hubject improve VDV 261 preconditioning
Vector has expanded its vCharM system and, with Hubject, has automated certificate management and added an IPv6-to-IPv4 proxy to simplify VDV 261 preconditioning deployment for electric bus fleets.
Arrow launches E/E architecture initiative
Arrow Electronics has introduced an E/E architecture initiative and online research hub to support OEMs and suppliers with integrated compute platforms, software and supply‑chain services, and has aggregated hardware, software and engineering expertise to address vehicle E/E complexity.
Kapsch and NCTA launch live C-V2X tolling system
Kapsch TrafficCom and the North Carolina Turnpike Authority have deployed a production C-V2X tolling system on NC-540 and have integrated roadside units with NCTA's back office, and have appended connected-vehicle data to toll transactions to validate end-to-end operations.
Heilind adds Molex FAKRA‑Mini to automotive range
Heilind Electronics has added the Molex High‑Speed FAKRA‑Mini interconnect system to its automotive portfolio and has provided connectors supporting up to 28 Gbps and multiple automotive protocols for space‑constrained vehicle connectivity.
Kapsch Launches EcoTrafiX Connected Tolling Platform
Kapsch TrafficCom has launched the EcoTrafiX platform and has demonstrated simultaneous toll processing from 5G Network V2X and 5.9 GHz direct C‑V2X, validating a unified back-office for agency toll management and interoperability.
Valeo and Kapsch develop V2X tolling solution
Valeo and Kapsch have partnered to develop a C‑V2X tolling system and have demonstrated it at a 5GAA meeting; the system has been designed to enable direct vehicle‑to‑roadside transactions and reduce reliance on traditional toll infrastructure.
SAESOL Tech and UNEX to test V2X security interoperability
SAESOL Tech and UNEX have signed a memorandum of understanding to validate SCMS interoperability with IEEE 1609.2‑compliant V2X devices, share test data and co‑host demonstrations to advance standards‑aligned deployments.
Ethernovia raises $90m for Ethernet AI networking chips
Ethernovia raised more than $90m in a Series B to develop Ethernet packet processors and networking chips for autonomous vehicles, robotics and industrial systems and expand product and customer engagements.
Eye-Net showcases V2X beyond-line-of-sight collision system
Eye-Net Mobile presented a commercial V2X system at CES 2026 that uses cellular networks to share safety data beyond line of sight, integrating with vehicle platforms and smart devices.
V2X Tolling Enters Production Deployment
Kapsch and NCTA launched a production V2X tolling system enabling in‑vehicle transactions, reducing roadside infrastructure, using the 5.9 GHz safety band and requiring strategic agency deployment.
Marelli launches 5G RedCap telematics solution
Marelli introduced a 5G RedCap telematics module offering higher throughput and lower latency than 4G, network fallback, regional compliance, and production samples in early 2026 with mass production from 2028.
I-485 Express Lanes implement live C-V2X tolling
Indra and NCTA completed testing of a live C‑V2X tolling and LiDAR safety system on I‑485, enabling in‑vehicle real-time toll notifications and planned full-corridor rollout.
Valens and imavix launch MIPI A-PHY production platform
Valens, imavix and CIS launched a production-ready MIPI A-PHY platform and compliant camera, enabling long-reach, high-bandwidth industrial vision connectivity compatible with existing GigE Vision systems.
Hyundai Motor Group expands V2G and V2H services globally
Hyundai Motor Group will deploy vehicle-to-grid and vehicle-to-home services in Korea, the Netherlands and the US, piloting V2G on Jeju Island and commercial rollout by 2025.
Webinar on V2X Tolling Technology and Industry Impacts
TTi and Kapsch TrafficCom will host a 4 December 2025 webinar on V2X tolling, convening industry stakeholders to discuss deployment challenges, financial sustainability, and lessons from North Carolina's pilot.
Microchip launches 10BASE-T1S endpoints for zonal Ethernet
Microchip has introduced LAN866x 10BASE-T1S endpoints enabling software-less Ethernet-to-local-interface translation, supporting multidrop zonal architectures to reduce cabling, integration complexity and per-node hardware.
UMT and CEVA launch HyperMotion 5G RedCap platform
Collaboration delivers HyperMotion 5G RedCap platform combining UMT SoC and CEVA modem IP to enable cost-efficient automotive telematics and C-V2X with automotive-grade features and hardware offloading.
Cupra Born V2G potential and Australian readiness
Cupra Born models with 77 kWh MEB batteries can support bidirectional charging via software updates in Europe; Australian activation depends on importer support, compatible chargers and regulatory approval for V2G.
RedEarth Launches 11kW V2G EV Charger with Pre-Orders in November
RedEarth Energy Storage will offer its 11kW three-phase vehicle-to-grid charger in Australia from February 2026, allowing EV batteries to interact with home energy systems and wholesale markets.
Microchip and AVIVA Links Achieve ASA-ML Chipset Interoperability
Microchip and AVIVA Links demonstrated interoperability of ASA-ML chipsets, supporting open automotive connectivity standards and facilitating scalable, multi-vendor vehicle network integration.
Keysight Launches Optical Ethernet Test System for Automotive Use
Keysight Technologies has introduced the AE6980T test solution for validating optical automotive Ethernet transmitters, supporting IEEE 802.3cz standards and enhancing in-vehicle network performance.
OPEN Alliance and AUTOSAR Collaborate on Ethernet Vehicle Networking
OPEN Alliance and AUTOSAR partner to develop standardised Ethernet specifications for automotive networking, focusing on functional safety, cybersecurity, and interoperability to support next-generation vehicle systems.
TE Connectivity Launches New Connector Range for Vehicle ECUs
TE Connectivity introduces its Inside Device Connectivity line, designed for next-generation vehicle ECUs, supporting compact, robust and high-performance electrical architectures in automotive applications.
Cohda Wireless OBU Secures E1 Certification in EU
Cohda Wireless has obtained E1 certification for its On-Board Unit, meeting EU safety and regulatory standards for deployment in public transport and aftermarket applications.
Indra Implements C-V2X Tolling on North Carolina Expressway
Indra introduces C-V2X tolling technology on North Carolina's I-485, enhancing interoperability and integrating toll information directly with connected vehicles' systems.
MIPI A-PHY Standard Enters Mass Production for Automotive SerDes
MIPI Alliance's A-PHY specification has reached mass production, enabling standardised automotive SerDes technology for high-speed sensor and display connectivity in vehicles.
Pilotfish Unveils VG212 Gateway for Public Transit Connectivity
Pilotfish launches VG212 Vehicle Gateway offering dual 4G/5G connectivity and advanced features to enhance public transit fleet management and data integration, shipping Q3 2025.
Octopus Energy to Launch V2G Technology and EV Leasing in Germany
Octopus Energy will introduce vehicle-to-grid technology and an EV leasing service in Germany by early 2026, expanding its UK EV innovations to the German market.
Atlanta Launches First US C-V2X Deployment District
Atlanta has established the first US C-V2X Day One Deployment District, enhancing traffic infrastructure to improve road safety and reduce congestion, signalling readiness for wider national adoption.
Atlanta Launches First US C-V2X ‘Day One Deployment District’
Atlanta establishes the first US ‘Day One Deployment District’ for C-V2X technology, highlighting enhanced road safety and operational efficiencies as part of nationwide connected vehicle initiatives.
IRF Highlights CCAM Innovation at ITS World Congress 2025
IRF Acting DG Gonzalo Alcaraz emphasised the necessity of innovation in Cooperative, Connected and Automated Mobility, outlining infrastructure, communication, and safety strategies at ITS World Congress 2025.
Eaton and ChargePoint Unveil Ultrafast V2X EV Charging Solution
Eaton and ChargePoint introduce a V2X ultrafast DC charging system delivering up to 600kW for passenger EVs and megawatt capacity for heavy-duty vehicles, enhancing grid integration and cost efficiency.
Kapsch RIS-9360 Achieves OmniAir Certification for C-V2X RSU
Kapsch TrafficCom's RIS-9360 roadside unit has gained OmniAir Certification, confirming compliance with LTE-V2X standards and supporting scalable connected vehicle infrastructure.
Indra to Deploy C-V2X Tolling on I-485 Express Lanes
Indra will implement its C-V2X connected vehicle tolling system on North Carolina's I-485 Express Lanes, enhancing toll payment efficiency and road safety through advanced sensor technology.
Indra Launches C-V2X Tolling on NC I-485 Express Lanes
Indra introduces connected vehicle tolling on I-485 Express Lanes, enhancing toll interoperability and road safety using C-V2X and LiDAR technologies in North Carolina.
Denmark's HGV Toll System Utilises Kapsch TrafficCom Tech
Denmark has implemented a satellite-based toll system for heavy goods vehicles using Kapsch TrafficCom's hardware and software, enhancing precision and environmental considerations in tolling.
NCTA and Kapsch to launch V2X tolling system on NC-540
The North Carolina Turnpike Authority and Kapsch TrafficCom will deploy the first production-level Vehicle-to-Everything tolling system on the Triangle Expressway, advancing connected vehicle infrastructure.
North Carolina Launches Production-Ready V2X Toll System
The North Carolina Turnpike Authority and Kapsch TrafficCom deploy a live V2X tolling solution on NC-540, integrating connected-vehicle data with legacy tolling for streamlined invoicing and reduced leakage.
NCTA and Kapsch Launch First Production-Ready V2X Toll System
The North Carolina Turnpike Authority and Kapsch TrafficCom have deployed the first operational V2X-based tolling system on the Triangle Expressway, integrating legacy and connected vehicle technologies.
Kapsch and Audi Present V2X Tolling Roadmap for North America
Kapsch TrafficCom and Audi have outlined a V2X tolling strategy aimed at addressing North America’s infrastructure funding gap via scalable, interoperable vehicle payment systems.
Kapsch TrafficCom to Present Transportation Technologies at ITS World Congress
Kapsch TrafficCom will demonstrate its transportation technology solutions, including traffic data analytics and V2X tolling, at the ITS World Congress in Atlanta, highlighting various projects and expert sessions.
